CVE-2026-73072
Vim is an open source, command line text editor. Prior to 9.2.0846, set_sofo() in src/spellfile.c reuses sl_sal_first[] without resetting va
CVSS
7.3
High
EPSS
0.1%
p1
KEV
—
Exploit Today
0
0-100
Published: Aug 11, 2026 · Last modified: Oct 6, 2026 · CWE-122 · CWE-787
0.1%EPSS · 30 days0.1%
2026-09-252026-10-23
Vim is an open source, command line text editor. Prior to 9.2.0846, set_sofo() in src/spellfile.c reuses sl_sal_first[] without resetting values left by set_sal_first(), so a crafted spell file containing an SN_SAL section before an SN_SOFO section causes under-counted mapping lists and attacker-influenced writes beyond a heap allocation. This issue is fixed in version 9.2.0846.
CVECVSSEPSSKEVRExploitTitleMod.
CVE-2026-799828.8 HIG—
——0The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and into whatever follows the statically allocated pool.
The device runs the local Bluetooth controller in raw HCI mode (CONFIG_BT_HCI_RAW), so the oversized packets originate over the air. With the HCI buffer sizes recommended for full-featured controllers, an unauthenticated attacker within Bluetooth range can supply the overflowing bytes: a connected peer that negotiates Data Length Extension can send ACL fragments up to CONFIG_BT_CTLR_DATA_LENGTH_MAX bytes, and an attacker that merely broadcasts extended advertising data reaches the same path through LE Extended Advertising Report events, which the controller fragments only to CONFIG_BT_BUF_EVT_RX_SIZE. In the stock configuration the overflow is already reached without any radio traffic: the mandatory Read Supported Commands command-complete event is 70 bytes and overruns the 64-byte slot by six bytes on every host initialization.
Because net_buf_add_mem() validates tailroom only through an assertion unless CONFIG_NET_BUF_HARDENING is enabled, builds with CONFIG_ASSERT=n — the usual production setting — silently corrupt memory adjacent to the USB buffer pool with attacker-chosen contents, which on a target without memory protection between subsystems can lead to arbitrary code execution. Builds with assertions enabled fail the assertion instead and panic, giving a remotely triggerable denial of service. The fix introduces a separate bt_hci_tx_pool sized to MAX(BT_BUF_ACL_RX_SIZE, BT_BUF_EVT_RX_SIZE) for the controller-to-host direction while leaving the host-to-device pool at the endpoint packet size, which is already bounds-checked during reassembly.1dCVE-2026-799783.6 LOW—
——0The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well.
A short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) — for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation — takes this path whenever the pool is fragmented or the consuming thread falls behind.
The out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code.1dCVE-2026-1157237.4 HIG—
——0Snap7 through 1.4.3 contains an out-of-bounds write vulnerability in the passive partner that allows a malicious active partner to overflow application buffers by declaring an unvalidated BSend total length. Attackers connecting from the configured peer address can declare up to 65535 bytes and send a short fragment, causing BRecv to memcpy past the buffer and crash or corrupt SCADA, HMI or gateway processes.1dCVE-2026-1155047.8 HIG2.7%
——1CFITSIO through 4.7.0 contains an out-of-bounds write vulnerability in ffgcls2() in getcols.c that trusts attacker-controlled heap descriptor lengths for variable-length string columns. Attackers can supply a crafted FITS file that overflows a fixed 28,800-byte stack buffer and the caller's string array, enabling arbitrary code execution.1dCVE-2026-1153933.8 LOW0.5%
——0Wasmtime before 24.0.12, 25.0.0 before 36.0.13, 37.0.0 before 46.0.2, and 47.0.0 before 47.0.3 contains a type confusion vulnerability because several Store APIs fail to validate that objects belong to the Store's Engine. Embedders mixing objects between Engines via Instance::new, StructRefPre::new, or Tag::new can trigger trampoline signature mismatches causing out-of-bounds stack writes, GC heap corruption, or panics.2dCVE-2026-111497—40.5%
——12A buffer overflow vulnerability in the Brotli decoder (c/dec/decode.c) in Google Brotli versions 1.0.3 through 1.2.0 on all platforms allows a remote unauthenticated attacker to corrupt adjacent decoder state memory, disclose sensitive memory contents, cause a denial of service, or potentially execute arbitrary code using a crafted Brotli-compressed stream.
Users need to update any Brotli libraries or binaries between 1.0.3 through 1.2.0 to the latest available version: 1.0.10 or 1.1.1 or 1.2.1.4h