CVE Watch356,684 in full archive

Vulnerabilities exploitable today

356,684in current view

Single score combining CVSS, KEV membership and EPSS. Every CVE with its own record — timeline from publication to active exploitation.

In KEV catalog1,662

New KEV · 24H0

Exploit Today ≥ 701,605

Distribution · last window

Critical
2,538
High
10,643
Medium
6,744
Low
670

Filters

Window

Severity

Flags

Vulnerabilities327,081–327,120 · 356,684

CVECVSSEPSSKEVRExploitTitleMod.

——2In the Linux kernel, the following vulnerability has been resolved: hwmon: (pmbus/adm1266) reject implausible blackbox record_count adm1266_nvmem_read_blackbox() loops over a record_count that comes straight from byte 3 of the BLACKBOX_INFO response. The destination buffer is data->dev_mem, sized for the nvmem cell's declared 2048 bytes (ADM1266_BLACKBOX_MAX_RECORDS * ADM1266_BLACKBOX_SIZE = 32 * 64). A device that reports a record_count greater than 32 -- whether due to firmware bugs, bus corruption, or a non-responsive slave returning 0xff -- would walk read_buff past the end of the dev_mem allocation on the trailing iterations. Cap record_count at ADM1266_BLACKBOX_MAX_RECORDS (introduced here) before entering the loop and return -EIO on any larger value, so a malformed BLACKBOX_INFO response cannot drive the loop out of bounds.9d CVE-2026-64461—

8.2%

——2In the Linux kernel, the following vulnerability has been resolved: PCI: mediatek: Fix IRQ domain leak when port fails to enable When mtk_pcie_enable_port() fails, mtk_pcie_port_free() removes the port from pcie->ports and frees the port structure. However, the IRQ domains set up earlier by mtk_pcie_init_irq_domain() are never freed. Fix this by refactoring mtk_pcie_irq_teardown() into a per-port helper, mtk_pcie_irq_teardown_port(), and calling it from mtk_pcie_setup() when mtk_pcie_enable_port() fails. Since the IRQ teardown must only happen in the probe error path (during resume, child devices may have active MSI mappings and the NOIRQ context prohibits sleeping locks), mtk_pcie_enable_port() is changed to return an error code so callers can distinguish the two paths and act accordingly. This issue was reported by Sashiko while reviewing the EcoNet EN7528 SoC support series.15d CVE-2025-43767—

——2In the Linux kernel, the following vulnerability has been resolved: ALSA: caiaq: fix out-of-bounds read in the Traktor Kontrol S4 input parser snd_usb_caiaq_tks4_dispatch() decodes the Traktor Kontrol S4 input stream in fixed 16-byte (TKS4_MSGBLOCK_SIZE) message blocks. On every iteration it advances buf and subtracts the block size while looping on "while (len)". len is urb->actual_length. That value is supplied by the device and is not guaranteed to be a multiple of 16. When a final short block leaves len between 1 and 15, the loop runs once more, reads up to buf[15], and then does "len -= TKS4_MSGBLOCK_SIZE". As len is unsigned this underflows to a huge value. The loop then keeps iterating and walking buf far past the end of the 512-byte ep4_in_buf, reading out of bounds until a bogus block id happens to be hit. Iterate only while a full message block is available. This stops the unsigned underflow and silently drops any trailing partial block, which carries no complete control value anyway. The sibling endpoint-4 parsers are not affected. The Traktor Kontrol X1 and Maschine arms in snd_usb_caiaq_ep4_reply_dispatch() floor urb->actual_length before dispatching.15d CVE-2023-38300—

——2In the Linux kernel, the following vulnerability has been resolved: USB: chaoskey: Fix slab-use-after-free in chaoskey_release() The chaoskey driver has a use-after-free bug in its release routine. If the user closes the device file after the USB device has been unplugged, a debugging log statement will try to access the usb_interface structure after it has been deallocated: BUG: KASAN: slab-use-after-free in dev_driver_string (drivers/base/core.c:2406) Read of size 8 at addr ffff888168e8a0b8 by task chaoskey_raw_re/10106 Hardware name: QEMU Ubuntu 24.04 PC v2 (i440FX + PIIX, arch_caps fix, 1996), BIOS 1.16.3-debian-1.16.3-2 04/01/2014 Call Trace: <TASK> dump_stack_lvl (lib/dump_stack.c:94 lib/dump_stack.c:120) print_report (mm/kasan/report.c:378 mm/kasan/report.c:482) kasan_report (mm/kasan/report.c:595) dev_driver_string (drivers/base/core.c:2406) __dynamic_dev_dbg (lib/dynamic_debug.c:906) chaoskey_release (drivers/usb/misc/chaoskey.c:323) __fput (fs/file_table.c:510) fput_close_sync (fs/file_table.c:615) __x64_sys_close (fs/open.c:1507 fs/open.c:1492 fs/open.c:1492) do_syscall_64 (arch/x86/entry/syscall_64.c:63 arch/x86/entry/syscall_64.c:94) entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:121) The driver's last reference to the interface structure is dropped in the chaoskey_free() routine, so the code must not use the interface -- even in a debugging statement -- after that routine returns. (Exception: If we know that another reference is held by someone else, such as the device core while the disconnect routine runs, there's no problem. Thanks to Johan Hovold for pointing this out.) Since the bad access is part of an unimportant debugging statement, we can fix the problem simply by removing the whole statement.15d CVE-2019-2199—

——2In the Linux kernel, the following vulnerability has been resolved: ALSA: usb-audio: avoid kobject path lookup in DualSense match The DualSense jack-detection input handler verifies that a matching input device belongs to the same physical controller by building kobject path strings for both the input device and the USB audio device, then comparing the path prefix. This was observed when a weak physical connection caused the controller to rapidly disconnect and reconnect. During that repeated hotplug, snd_dualsense_ih_match() can run while the controller's USB device is being disconnected. kobject_get_path() walks ancestor kobjects and dereferences their names; if the USB device kobject name is no longer valid, this can fault in strlen(): RIP: 0010:strlen+0x10/0x30 Call Trace: kobject_get_path+0x34/0x150 snd_dualsense_ih_match+0x49/0xd0 [snd_usb_audio] input_register_device+0x566/0x6a0 ps_probe+0xb89/0x1590 [hid_playstation] The same ownership check can be done without building kobject path strings. The input device is parented below the HID device, USB interface and USB device, so walking the input device parent chain and comparing against the mixer USB device preserves the check without dereferencing kobject names during disconnect.15d CVE-2026-52779—

8.2%

——2——CVE-2026-150636.3 MED

8.2%

——2A flaw was found in the gorch service template, which is part of the trustyai-service-operator. Even when authentication is enabled, the gorch service exposes unproxied orchestrator and detector metrics ports. This allows any pod on the cluster network to directly access these ports, bypassing the kube-rbac-proxy and its authentication mechanisms. This could lead to unauthorized access to the orchestrator and detector metrics.30d CVE-2026-42753—

8.2%

——2——CVE-2026-6495—

8.2%

——2——CVE-2025-558498.4 HIG

8.2%

——2WeiPHP v5.0 and before is vulnerable to SQL Injection via the SucaiController.class.php file and the cancelTemplatee35d CVE-2024-47884—

8.2%

——2——CVE-2026-452938.6 HIG

8.2%

——2WordPress Coding Standards is a set of PHP_CodeSniffer rules (sniffs) that enforce WordPress coding conventions. From 0.14.1 until 3.4.1, the WordPress.WP.EnqueuedResourceParameters sniff (active in the WordPress and WordPress-Extra rulesets) reconstructed the $ver argument passed to functions such as wp_enqueue_script() and ran it through eval() inside its is_falsy() method, so a maliciously crafted argument such as 'system'('id') would execute during a scan; as a result, running PHPCS with WordPressCS over untrusted PHP (for example a CI pipeline that lints pull requests, or a developer reviewing third-party code) could lead to arbitrary command execution on the scanning host. The WordPress-Core and WordPress-Docs rulesets are not affected. This issue is fixed in version 3.4.1.10d CVE-2026-236386.5 MED

8.2%

——2Kiteworks is a private data network (PDN). Prior to version 9.3.0, an Insecure Direct Object Reference (IDOR) vulnerability in Kiteworks Secure Data Forms allows an authenticated attacker to tamper with the internal approval flow configurations of forms belonging to other users due to insufficient authorization checks on resource ownership. Upgrade Kiteworks to version 9.3.0 or later to receive a patch.18d CVE-2026-21328—

——2——CVE-2025-382388.8 HIG

8.2%

——2In the Linux kernel, the following vulnerability has been resolved: scsi: fnic: Fix crash in fnic_wq_cmpl_handler when FDMI times out When both the RHBA and RPA FDMI requests time out, fnic reuses a frame to send ABTS for each of them. On send completion, this causes an attempt to free the same frame twice that leads to a crash. Fix crash by allocating separate frames for RHBA and RPA, and modify ABTS logic accordingly. Tested by checking MDS for FDMI information. Tested by using instrumented driver to: - Drop PLOGI response - Drop RHBA response - Drop RPA response - Drop RHBA and RPA response - Drop PLOGI response + ABTS response - Drop RHBA response + ABTS response - Drop RPA response + ABTS response - Drop RHBA and RPA response + ABTS response for both of them10d CVE-2025-40700—

8.2%

——2——CVE-2026-151635.5 MED

8.2%

——2Multiple protocol dissector infinite loops in Wireshark 4.6.0 to 4.6.6 and 4.4.0 to 4.4.16 allow denial of service30d