CVE Watch6 oct 2026

CVE-2026-105248

A security flaw has been discovered in vgmstream up to r2117. This affects the function parse_params/txtp_parse of the file src/meta/txtp_pa

CVSS

6.3

Medio

EPSS

0.2%

p14

KEV

—

Exploit Today

0-100

Publicado: 5 oct 2026 · Última mod.: 6 oct 2026 · CWE-119 · CWE-787

EPSS · 30d

0.2%EPSS · 30 días0.2%

2026-10-052026-10-23

Descripción técnica

A security flaw has been discovered in vgmstream up to r2117. This affects the function parse_params/txtp_parse of the file src/meta/txtp_parser.c of the component TXTP File Handler. The manipulation results in out-of-bounds write. The attack may be launched remotely. The patch is identified as 4669d37a6af94866f6f0628678f9f90d46954e8b. It is best practice to apply a patch to resolve this issue.

Referencias oficiales

CVEs relacionados

CVECVSSEPSSKEVRExplotTítuloVis.

CVE-2026-1158015.3 MED

—

———A security flaw has been discovered in Kakao khaiii up to 0.4. The impacted element is the function khaiii::nn::Linear::open of the file src/main/cpp/khaiii/nn/Linear.cpp of the component JSON Config File Handler. The manipulation of the argument hidden_dim/class_num results in out-of-bounds read. The attack requires a local approach. The exploit has been released to the public and may be used for attacks. The vendor explains: "khaiii treats the resource directory (--rsc-dir) as trusted input, like a binary or a shared library. To use this defect, an attacker must already be able to write to that directory. With that access, an attacker can change the analysis results without this defect." This vulnerability only affects products that are no longer supported by the maintainer.3h CVE-2026-799828.8 ALT

—

———The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and into whatever follows the statically allocated pool. The device runs the local Bluetooth controller in raw HCI mode (CONFIG_BT_HCI_RAW), so the oversized packets originate over the air. With the HCI buffer sizes recommended for full-featured controllers, an unauthenticated attacker within Bluetooth range can supply the overflowing bytes: a connected peer that negotiates Data Length Extension can send ACL fragments up to CONFIG_BT_CTLR_DATA_LENGTH_MAX bytes, and an attacker that merely broadcasts extended advertising data reaches the same path through LE Extended Advertising Report events, which the controller fragments only to CONFIG_BT_BUF_EVT_RX_SIZE. In the stock configuration the overflow is already reached without any radio traffic: the mandatory Read Supported Commands command-complete event is 70 bytes and overruns the 64-byte slot by six bytes on every host initialization. Because net_buf_add_mem() validates tailroom only through an assertion unless CONFIG_NET_BUF_HARDENING is enabled, builds with CONFIG_ASSERT=n — the usual production setting — silently corrupt memory adjacent to the USB buffer pool with attacker-chosen contents, which on a target without memory protection between subsystems can lead to arbitrary code execution. Builds with assertions enabled fail the assertion instead and panic, giving a remotely triggerable denial of service. The fix introduces a separate bt_hci_tx_pool sized to MAX(BT_BUF_ACL_RX_SIZE, BT_BUF_EVT_RX_SIZE) for the controller-to-host direction while leaving the host-to-device pool at the endpoint packet size, which is already bounds-checked during reassembly.5h CVE-2026-799783.6 BAJ

—

———The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well. A short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) — for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation — takes this path whenever the pool is fragmented or the consuming thread falls behind. The out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code.5h CVE-2026-1157237.4 ALT

—

———Snap7 through 1.4.3 contains an out-of-bounds write vulnerability in the passive partner that allows a malicious active partner to overflow application buffers by declaring an unvalidated BSend total length. Attackers connecting from the configured peer address can declare up to 65535 bytes and send a short fragment, causing BRecv to memcpy past the buffer and crash or corrupt SCADA, HMI or gateway processes.10h CVE-2026-1155047.8 ALT

2.7%

——1CFITSIO through 4.7.0 contains an out-of-bounds write vulnerability in ffgcls2() in getcols.c that trusts attacker-controlled heap descriptor lengths for variable-length string columns. Attackers can supply a crafted FITS file that overflows a fixed 28,800-byte stack buffer and the caller's string array, enabling arbitrary code execution.6h CVE-2026-957213.3 BAJ

0.2%

——0A memory corruption vulnerability exists in the web-based management interface of AOS-8. Successful exploitation could allow an authenticated low privilege attacker with local access to view some system files and interrupt the normal operation of the affected service.5h