CVE Watch11 ago 2026

CVE-2026-64183

In the Linux kernel, the following vulnerability has been resolved: efi: Allocate runtime workqueue before ACPI init Since commit 5894c

CVSS

5.5

Medio

EPSS

0.1%

KEV

—

Exploit Today

0-100

Publicado: 19 jul 2026 · Última mod.: 11 ago 2026 · CWE-476

EPSS · 30d

0.1%EPSS · 30 días0.2%

2026-09-262026-10-23

Descripción técnica

In the Linux kernel, the following vulnerability has been resolved: efi: Allocate runtime workqueue before ACPI init Since commit 5894cf571e14 ("acpi/prmt: Use EFI runtime sandbox to invoke PRM handlers") ACPI PRM calls are delegated to a workqueue which runs in a kernel thread, making it easier to detect and mitigate faulting memory accesses performed by the firmware. Rafael reports that such PRM accesses may occur before efisubsys_init() executes, which is where the workqueue is allocated, leading to NULL pointer dereferences. Since acpi_init() [which triggers the early PRM accesses] executes as a subsys_initcall() as well, and has its own dependencies that may be sensitive to initcall ordering, deferring acpi_init() is not an option. So instead, split off the workqueue allocation into its own postcore initcall, as this is the only missing piece to allow EFI runtime calls to be made. This ensures that EFI runtime call (including PRM calls) are accessible to all code running at subsys_initcall() level.

Referencias oficiales

CVEs relacionados

CVECVSSEPSSKEVRExplotTítuloVis.

CVE-2026-1104917.5 ALT

31.4%

——9The ONVIF service on the E3 can be rendered unresponsive by sending malformed or incomplete requests to certain operations. The affected service stops accepting new connections while the rest of the device continues operating normally, and will recover automatically after a period. This can be triggered repeatedly by any unauthenticated party with network access to the device.1d CVE-2026-1123815.9 MED

16.2%

——5Apache Traffic Server can crash with a null pointer dereference when a client POST request is torn down via half-close while a chunked origin response is being reparsed from a reentrant write-ready callback, a timing-dependent race introduced by the CVE-2021-32564 flow-control backports. This issue affects Apache Traffic Server: 9.2.15, 10.1.4, 10.2.0. Users are recommended to upgrade to version 9.2.16, 10.1.5, or 10.2.1, which fix the issue.1d CVE-2026-799767.1 ALT

10.2%

——3The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes. The selected register (b->reg_addr) and the data-phase flag (b->rxtx) were never cleared when the controller issued an I2C STOP, so after a completed transfer the target still had a data register selected while the packet buffer that register refers to had already been consumed and set to NULL by mctp_i2c_gpio_target_stop(). A controller on the bus can re-enter the same branch of mctp_i2c_gpio_target_stop() with a NULL buffer using two ordinary transactions and no authentication: first a normal packet write to MCTP_I2C_GPIO_RX_MSG_ADDR followed by STOP (which delivers and frees b->rx_pkt), then a bare read transaction followed by STOP. The failing read_requested() call leaves the stale state untouched and the I2C driver still delivers the STOP callback, which then calls mctp_bus_rx() with a NULL packet. The symmetric case exists on the transmit side, where the stale MCTP_I2C_GPIO_TX_MSG_ADDR selection dereferences b->tx_pkt->end after b->tx_pkt has been cleared and additionally signals b->tx_complete a second time, causing the next outbound packet to be dropped. The dereference happens in the I2C target interrupt handler, so on any target that traps accesses to address 0 the result is a fatal exception and a device reset or halt — a denial of service inflicted by any device able to act as controller on the shared management bus (for example compromised firmware on a peer MCTP endpoint or on the BMC). On parts where address 0 is readable, the impact degrades to a malformed packet buffer being handed to the MCTP stack and lost transmit packets. No attacker-controlled value is written and no confidentiality or integrity boundary is crossed. The fix resets b->reg_addr to MCTP_I2C_GPIO_INVALID_ADDR and clears b->rxtx at every STOP, so a new register must be selected before any data phase can run again. Only builds that opt into the experimental CONFIG_MCTP subsystem with CONFIG_MCTP_I2C_GPIO_TARGET=y are affected.1d CVE-2026-764927.5 ALT

17.2%

——5As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco Expressway Series software engineering team has conducted a comprehensive internal security review. This review resulted in software hardening releases that address multiple internally discovered vulnerabilities.   The vulnerabilities tracked by CVE-2026-76492 are related to issues concerning null pointers that are grouped under the Common Weakness Enumeration (CWE) Base CWE-476.3d CVE-2026-202215.8 MED

38.5%

——12Multiple Cisco products are affected by a vulnerability in the generic routing encapsulation (GRE) tunnel decapsulation feature of the Snort 3 Detection Engine that could allow an unauthenticated, remote attacker to cause an unexpected restart of the Snort 3 Detection Engine. This vulnerability is due to improper handling of nested GRE traffic. An attacker could exploit this vulnerability by sending a crafted GRE payload through an affected device. A successful exploit could allow the attacker to trigger an unexpected reload of the Snort 3 Detection Engine, resulting in either a bypass or denial of service (DoS) condition, depending on device configuration. For more information, see the section of this advisory. The Snort 3 Detection Engine will restart automatically. No manual intervention is required.3d CVE-2026-968887.5 ALT

39.0%

——12A BIND resolver that is configured with both a "redirect" zone and "qname-minimization strict" may abort with an assertion failure while processing the redirect. This issue affects BIND 9 versions 9.16.0 through 9.18.50, 9.20.0 through 9.20.29, 9.21.0 through 9.21.26, 9.16.8-S1 through 9.18.50-S1, and 9.20.9-S1 through 9.20.29-S1.4d