PULSE
EN VIVO0señales / 24h
FEED
vulnKEV agrega CVE-2023-49105 — ownCloud / ownCloudvulnKEV agrega CVE-2026-53362 — Linux / KernelvulnKEV agrega CVE-2026-66384 — JFrog / ArtifactoryvulnKEV agrega CVE-2021-23758 — Ajax.NET Professional / Ajax.NET ProfessionalvulnKEV agrega CVE-2015-3246 — Red Hat / LibuservulnKEV agrega CVE-2015-5287 — Red Hat / Automatic Bug Reporting ToolvulnKEV agrega CVE-2022-0995 — Linux / KernelvulnKEV agrega CVE-2026-8452 — Citrix / NetScaler ADC and NetScaler GatewayvulnKEV agrega CVE-2019-1068 — Microsoft / SQL ServervulnKEV agrega CVE-2026-60004 — Gitea / GiteavulnKEV agrega CVE-2026-21962 — Oracle / HTTP Server and Oracle Weblogic Server Proxy Plug-invulnKEV agrega CVE-2026-73570 — Synacor / Zimbra Collaboration Suite (ZCS)vulnKEV agrega CVE-2026-72530 — TrueConf / ServervulnKEV agrega CVE-2026-72529 — TrueConf / ServervulnKEV agrega CVE-2023-49105 — ownCloud / ownCloudvulnKEV agrega CVE-2026-53362 — Linux / KernelvulnKEV agrega CVE-2026-66384 — JFrog / ArtifactoryvulnKEV agrega CVE-2021-23758 — Ajax.NET Professional / Ajax.NET ProfessionalvulnKEV agrega CVE-2015-3246 — Red Hat / LibuservulnKEV agrega CVE-2015-5287 — Red Hat / Automatic Bug Reporting ToolvulnKEV agrega CVE-2022-0995 — Linux / KernelvulnKEV agrega CVE-2026-8452 — Citrix / NetScaler ADC and NetScaler GatewayvulnKEV agrega CVE-2019-1068 — Microsoft / SQL ServervulnKEV agrega CVE-2026-60004 — Gitea / GiteavulnKEV agrega CVE-2026-21962 — Oracle / HTTP Server and Oracle Weblogic Server Proxy Plug-invulnKEV agrega CVE-2026-73570 — Synacor / Zimbra Collaboration Suite (ZCS)vulnKEV agrega CVE-2026-72530 — TrueConf / ServervulnKEV agrega CVE-2026-72529 — TrueConf / Server
← Todos los CVEs
CVE Watch28 ago 2026

CVE-2026-80712

In the Linux kernel, the following vulnerability has been resolved: spi: spi-qpic-snand: write the feature value before executing SET_FEATU

CVSS

Sin CVSS

EPSS

KEV

Exploit Today

0

0-100

Publicado: 28 ago 2026 · Última mod.: 28 ago 2026

EPSS · 30d

Sin historial EPSS suficiente todavía.

Descripción técnica

In the Linux kernel, the following vulnerability has been resolved: spi: spi-qpic-snand: write the feature value before executing SET_FEATURE qcom_spi_send_cmdaddr() programs NAND_FLASH_CMD/NAND_EXEC_CMD and submits the descriptors, which makes the controller execute the command immediately. For SPINAND_SET_FEATURE the value to be written is only placed into NAND_FLASH_FEATURES afterwards, by qcom_spi_io_op(), in a second submission - so the chip is programmed with whatever that register happened to hold from a previous operation, and the intended value is only applied by the *next* SET_FEATURE. Measured on a TP-Link Archer AX55 v1 (IPQ5018, ESMT F50L1G41LB): writing 0x40 to the configuration register (0xb0) leaves the chip at 0x00, and the subsequent write of 0x00 leaves it at 0x40 - every write lands one operation late. This stayed unnoticed until v6.18 added SPI-NAND OTP support together with OTP entries for ESMT chips. spinand_otp_rw() enables OTP mode, reads, and disables it again, and mtd_otp_nvmem_add() does this during MTD registration. With the off-by-one, the "disable" write actually applies the previously requested value, so CFG_OTP_ENABLE ends up set: the chip stays in OTP mode, every subsequent array read returns the OTP area instead of the array (UBI reports an empty device) and all writes fail with -EIO because the OTP area is write protected. On this board that makes the whole flash unusable and the device unbootable. Write the feature value into NAND_FLASH_FEATURES as part of the same transaction, before NAND_EXEC_CMD. While at it, copy only the bytes the operation actually carries - the previous code dereferenced a 4-byte pointer on a one-byte buffer (spinand->scratchbuf). With this patch the flash contents read back bit-identical to a known-good dump of the same board taken under the vendor firmware (md5-verified across partitions), and writes work.

Referencias oficiales
CVEs relacionados

Sin CVEs relacionados por CWE o producto.