CVE-2026-84479
WWBN AVideo (current e01e41ecc and earlier) makes three login-time security controls depend solely on the client-supplied User-Agent header.
CVSS
9.1
Crítico
EPSS
—
KEV
—
Exploit Today
—
0-100
Publicado: 1 sept 2026 · Última mod.: 1 sept 2026 · CWE-290
Sin historial EPSS suficiente todavía.
WWBN AVideo (current e01e41ecc and earlier) makes three login-time security controls depend solely on the client-supplied User-Agent header. The isAVideoEncoder()/isAVideoMobileApp() checks match HTTP_USER_AGENT against a hardcoded literal ("AVideoEncoder"/"AVideoMobileApp") with no IP check or shared secret. An attacker who submits valid credentials and sets User-Agent: AVideoEncoder bypasses two-factor authentication, skips brute-force captcha escalation, and avoids being recorded in the login/device audit history. No patch is available at the time of publication.
CVECVSSEPSSKEVRExplotTítuloVis.
CVE-2026-844767.5 ALT—
———WWBN AVideo fails to validate trusted proxies before accepting X-Real-IP and X-Forwarded-For headers, allowing attackers to spoof the client address used by enforceRateLimit(). Attackers can rotate the header value per request to bypass login rate limiting and perform unlimited credential guessing attacks.3hCVE-2026-737424.3 MED—
———A vulnerability in an API endpoint of HPE Networking Fabric Composer could allow an authenticated low privilege operator user to spoof the source address attributed to their requests. Successful exploitation could allow an attacker to cause inaccurate attribution information to be recorded on the affected system.5hCVE-2026-585758.8 ALT—
———Dell PowerStore contains an Authentication Bypass by Spoofing vulnerability. An authenticated attacker could potentially exploit this vulnerability to escalate privileges to Administrator.5hCVE-2026-822288.1 ALT—
———Unauthenticated Bypass Vulnerability in SiteGround Security <= 1.6.6 versions.5hCVE-2026-137353.7 BAJ15.8%
——5Zephyr's WireGuard implementation in subsys/net/lib/wireguard/wg_crypto.c mishandled keepalive packets. In wg_process_data_message(), any type-4 transport-data message whose payload was exactly 16 bytes (an empty plaintext plus a bare Poly1305 tag, i.e. a keepalive) was accepted and returned immediately, before wg_decrypt_packet() was ever called. The Poly1305 authentication tag was therefore never verified; the only preceding gates were a cleartext receiver-index lookup (get_peer_keypair_for_index() on the attacker-supplied data_hdr->receiver) and a non-cryptographic keypair validity/expiry check.
The path is reachable entirely from the network: inbound UDP on the WireGuard port is dispatched by wg_input() to handle_transport_data() and then wg_process_data_message(). The 32-bit receiver index is transmitted in cleartext in WireGuard handshake and data messages, so an on-path observer learns it directly and an off-path attacker can brute-force it against the UDP port. Given an active receiving-valid session for that index, an attacker could send a 16-byte garbage payload and have it accepted without possessing the session key.
On acceptance the unauthenticated message caused the management layer to observe a spoofed NET_EVENT_VPN_CONNECTED signal (setting peer->first_valid and notifying any net_mgmt listener) and incremented the keepalive-RX statistic. The impact is limited to integrity of this status signal: no plaintext is decrypted or injected, no key is disclosed, and the early-return path did not update the peer endpoint or liveness timers, so there is no traffic-injection, session-takeover, or availability consequence.
The fix removes the pre-decrypt early return so a 16-byte payload flows through wg_decrypt_packet(), which verifies the Poly1305 tag over the empty plaintext, followed by the existing anti-replay check; only an authenticated, non-replayed message is then recognised as a keepalive. Forged keepalives now fail the tag check and are counted as decrypt failures.13hCVE-2026-555847.5 ALT83.0%
——25phpSysInfo is a customizable PHP script that displays system information. Prior to 3.4.6, the PSI_ALLOWED access-control check in read_config.php trusts attacker-controlled X-Forwarded-For and Client-IP HTTP headers before REMOTE_ADDR. A remote unauthenticated attacker can supply an allowed address in one of these headers to impersonate a trusted client and access exposed hostname, kernel, CPU, memory, filesystem, and network-interface information. This issue is fixed in version 3.4.6.1d