CVE-2026-97876
A local attacker with control over GRUB's configuration can bypass lockdown restrictions when booting with Secure Boot and load an unsigned
CVSS
6.4
Medio
EPSS
0.1%
p1
KEV
—
Exploit Today
0
0-100
Publicado: 2 oct 2026 · Última mod.: 2 oct 2026 · CWE-822
0.1%EPSS · 30 días0.1%
2026-10-032026-10-23
A local attacker with control over GRUB's configuration can bypass lockdown restrictions when booting with Secure Boot and load an unsigned GRUB module, while GRUB continues to report lockdown is enabled. The vulnerability is caused by insufficient validation of the MMIO base address passed to the GRUB serial command. GRUB does not validate that the base address corresponds to a UART device, rather than being an arbitrary memory address. This allows an attacker to trick GRUB into writing non-arbitrary data at an attacker-controlled address, including resetting the grub_file_verifiers list in a way that disables the subsequent verification of loaded modules.
CVECVSSEPSSKEVRExplotTítuloVis.
CVE-2026-196767.8 ALT1.4%
——0The user-mode verifier for the peci_transfer() system call, z_vrfy_peci_transfer() in drivers/peci/peci_handlers.c, checked only the device object permission and copied the caller-supplied struct peci_msg with k_usermode_from_copy(). That copy validates the outer structure only; the buf pointers and len values inside the embedded struct peci_buf members tx_buffer and rx_buffer remained fully caller-controlled and were passed unchecked to the driver.
Every in-tree PECI driver dereferences those pointers in supervisor mode: peci_npcx_transfer() in drivers/peci/peci_npcx.c and peci_it8xxx2_transfer() in drivers/peci/peci_ite_it8xxx2.c copy hardware bytes into rx_buffer.buf[i] and read command bytes out of tx_buffer.buf[i], and peci_xec_read()/peci_xec_write() in drivers/peci/peci_mchp_xec.c do the same with no bound on rx_buffer.len at all. A user-mode thread that has been granted the PECI device object — the normal way an application exposes a device under CONFIG_USERSPACE — could therefore point rx_buffer.buf at kernel data structures and have the driver write hardware-supplied bytes there, or point tx_buffer.buf at kernel memory and have its contents pushed onto the PECI/eSPI out-of-band bus.
The impact is a full user-mode-to-kernel escape: an arbitrary kernel write primitive (integrity and, through it, code execution at supervisor privilege), an arbitrary kernel read disclosed to a PECI bus observer, and a trivially reachable supervisor-mode fault if an unmapped address is supplied. Exploitation requires CONFIG_USERSPACE=y, one of the PECI drivers enabled (CONFIG_PECI_NPCX, CONFIG_PECI_XEC or CONFIG_PECI_ITE_IT8XXX2), and local code execution in a user-mode thread holding the PECI device.
The fix adds K_SYSCALL_MEMORY_READ() and K_SYSCALL_MEMORY_WRITE() checks over the two embedded buffers, with a size_add_overflow() guard on the frame-check-sequence byte accounted for in the RX length.21hCVE-2026-1103225.5 MED1.4%
——0The PEAK-System PCAN type 0x4030 processing path fails to validate a selected/returned object pointer before dereferencing fixed fields during post-processing.4dCVE-2026-195956.1 MED1.3%
——0The user-mode syscall verifier z_vrfy_rtio_cqe_get_mempool_buffer() in subsys/rtio/rtio_syscalls.c validated its two output parameters, buff and buff_len, with K_SYSCALL_MEMORY_READ() rather than K_SYSCALL_MEMORY_WRITE(). Both are pure out-parameters: z_impl_rtio_cqe_get_mempool_buffer() stores the mempool buffer address and its length through them. The distinction is enforced by every architecture validator — arch_buffer_validate() on RISC-V PMP explicitly accepts the global __rom_region/__rodata_region for reads only, and the ARM MPU validators accept P_RO_U_RO and P_RW_U_RO regions for reads only — so a read-validated pointer is not necessarily writable by the calling thread.
An unprivileged user-mode thread that has been granted access to an RTIO context (rtio_access_grant()) can invoke the rtio_cqe_get_mempool_buffer() syscall with buff/buff_len pointing at memory it may read but not write, and with a completion-queue entry whose flags field it fully controls (only RTIO_CQE_FLAG_MEMPOOL_BUFFER in flags[7:0] is required; flags[19:8] and flags[31:20] supply the block index and count). The kernel then performs a pointer-sized and a 4-byte store through those addresses while running in supervisor mode. Reaching the store requires CONFIG_USERSPACE together with CONFIG_RTIO_SYS_MEM_BLOCKS, the configuration behind RTIO_DEFINE_WITH_MEMPOOL; without the latter the implementation returns -ENOTSUP and writes nothing.
Two outcomes follow. If the target lies in a memory-domain partition declared K_MEM_PARTITION_P_RW_U_RO (privileged read-write, user read-only), the kernel-mode store succeeds and deposits partly attacker-chosen values into memory the memory domain had marked read-only for that thread, bypassing the partition's write protection. If the target lies in globally readable but unwritable memory such as .text/.rodata in flash, the store faults in kernel mode; the fault is delivered to z_fatal_error() and the default k_sys_fatal_error_handler() halts or reboots the device, giving an unprivileged thread a reliable full denial of service.
The read-permission check does bound the damage: the address must still be readable by the calling thread, so kernel-private memory cannot be targeted and no confidential data is disclosed. The fix replaces both checks with K_SYSCALL_MEMORY_WRITE(), so a thread lacking write permission is terminated by K_OOPS before the implementation runs; the cqe argument correctly remains read-validated.4dCVE-2026-1084356.5 MED42.2%
——13Untrusted pointer dereference in Microsoft Office Word allows an unauthorized attacker to disclose information over a network.4dCVE-2026-969337.8 ALT22.7%
——7Untrusted pointer dereference in Windows COM+ Event System Service allows an authorized attacker to elevate privileges locally.8dCVE-2026-969317.8 ALT22.7%
——7Untrusted pointer dereference in Windows NTFS allows an authorized attacker to elevate privileges locally.8d