CVE-2026-120008
SAP NetWeaver (Internet Graphics Service) does not sufficiently validate certain input values within incoming requests. An unauthenticated u
CVSS
8.2
Alta
EPSS
—
KEV
—
Exploit Today
—
0-100
Publicado: 10 de nov. de 2026 · Última mod.: 10 de nov. de 2026 · CWE-787
Ainda não há histórico EPSS suficiente.
SAP NetWeaver (Internet Graphics Service) does not sufficiently validate certain input values within incoming requests. An unauthenticated user could send a specially crafted request to trigger an out-of-bounds memory write in a worker process. Successful exploitation could result in memory corruption or repeated termination of the affected process, resulting in a high impact on availability and a low impact on integrity with no impact on confidentiality.
CVECVSSEPSSKEVRExploitTítuloMod.
CVE-2026-917597.8 ALT—
———Out-of-Bounds Write Vulnerability in Hitachi Dynamic Link Manager for Linux.
This issue affects Hitachi Dynamic Link Manager for Linux: from 7.5.0-00 before 9.0.5-00.6hCVE-2026-88707——
———An
out-of-bounds write in certain ASUS Router firmware
allows an unauthenticated nearby user to send an HTTP request containing
parameters that exceed the buffer length, potentially overwriting other memory
regions or causing the system to crash.
Refer to the ' Security Update for ASUS Router Firmware ' section on the ASUS Security Advisory for more information.10hCVE-2026-769707.5 ALT—
———Due to a Memory Corruption vulnerability in Application Server ABAP for SAP NetWeaver and ABAP Platform, an unauthenticated attacker could send specially crafted requests to the application. If processed by the application, these requests could trigger a memory corruption condition in the parsing routine, which could cause the affected processes to crash and restart. By repeatedly sending such requests, the attacker could cause a sustained denial of service, leading to a high impact on availability. Confidentiality and integrity remain unaffected.11hCVE-2026-905917.5 ALT—
———The NXP ENET-QOS Ethernet driver's receive work handler eth_nxp_enet_qos_rx() in drivers/ethernet/eth_nxp_enet_qos hands each processed descriptor back to the DMA by writing desc->read.control = rx_desc_refresh_flags, which sets OWN_FLAG and BUF1_ADDR_VALID_FLAG. RDES0 of a receive descriptor is the DMA buffer address in read format, but the hardware write-back aliases that word with the VLAN tag fields (or, for a context descriptor, the timestamp low word), so it is destroyed on every completion. The success path rewrites desc->read.buf1_addr before re-arming; the four drop paths — errored or non-first descriptor, net_pkt_rx_alloc() failure, invalid descriptor length, and net_pkt_get_frag() failure — did not, re-arming the ring slot with the write-back residue as its DMA target address.
The drop paths are driven entirely by received traffic and need no privilege or special configuration. With the defaults for this driver (CONFIG_NET_BUF_DATA_SIZE of 128 and 16 receive descriptors) a single full-size frame consumes twelve ring slots and twelve K_NO_WAIT fragment allocations, so a short burst of frames sent to the device exhausts the receive pools and reaches the allocation-failure paths; a frame with a receive error, or any frame whose first descriptor was already dropped, reaches the non-first-descriptor path.
Once a slot has been poisoned, the DMA writes the next frame received in that slot to an address derived from the frame's VLAN tag fields rather than to a receive buffer. On the supported MCX SoCs that address falls in flash or reserved space, so the transfer raises a fatal bus error that the driver only logs — there is no reset or recovery path — and reception stops permanently until the device is rebooted; where the write is silently discarded instead, the untouched buffer is later handed to the network stack with a length, delivering stale buffer contents as if they were a received frame. A single triggering event is enough to make the condition persistent, so an attacker able to send traffic to the device can permanently disable its network interface.13hCVE-2026-738577.5 ALT—
———ModSecurity is an open source, cross platform web application firewall (WAF) engine for Apache, IIS and Nginx. From 3.0.15 until 3.0.17, XML request body processing with SecParseXmlIntoArgs set to On or OnlyArgs can leave XMLNodes::parsing_ctx_arg uninitialized in the SAX end-element callback. A single crafted unauthenticated HTTP request can make a worker dereference the pointer, resulting in a constant-value write to an attacker-controlled address. The resulting memory corruption can terminate the worker and may disclose memory or redirect execution. Earlier 3.0.x releases and ModSecurity 2.x do not use the affected path. This issue is fixed in version 3.0.17.13hCVE-2026-1220565.9 MÉD—
———A flaw was found in OpenSCAP. A heap-based buffer overflow can occur when processing a specially crafted Extensible Configuration Checklist Description Format (XCCDF) document using the sds-compose option. An attacker could exploit this vulnerability to corrupt memory, resulting in an application crash and a Denial of Service (DoS).13h